PORSCHE 997 ACCEL
Can't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 914 1970-76 (includes uncategorized and accessory items)
Known as: bearing sleeve
View/Change Diagram
From $1.80
Make a selection
Fits 1965-1989.
View/Change Diagram
From $1.75
Make a selection
Known as: accelerator control
View/Change Diagram
At last a bracket to hold the end of the 914 accelerator cable when converting to carburation. Easily installed in the casing, this eliminates fabricating your own.
Known as: rubber sleeve
View/Change Diagram
From $9.54
Make a selection
Replaces worn and defective accelerator pump diaphragm to eliminate hesitation and stumble during acceleration. Fits just like original parts. Manufactured from fuel resistant, rubber membrane with silicon bronze center plunger hardware. Fits weber 32-36 dgv 5a / 32/36 dgev 38mm
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
Known as: reverse lever
View/Change Diagram
From $95.28
Make a selection
Replace your worn our gas pedal on your Porsche 911 or 914 with our brand new replacements.
View/Change Diagram
From $1.00
Make a selection
A worn bell crank bushing / bearing sleeve can cause binding. Several are commonly used on the accelerator pedal linkage. When they fail the pedal will bind up causing poor throttle response and a sticky pedal feel. High-quality OEM replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. Sold individually.
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
View/Change Diagram
From $2.63
Make a selection
This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.
View/Change Diagram
From $24.50
Make a selection
This linkage kit is a must for your 914-6 restoration or six conversion. The kit includes a 914-6 accelerator cable with jamb nuts and ball cup, linkage pull rod with ball cup, mounting bracket, bell crank with bushings, and protective rubber cable bellows.
Note: this kit is specifically for vehicles with dme injection.
General Fitment 914 1970-76
Replaces worn and defective accelerator pump diaphragm to eliminate hesitation and stumble during acceleration. Fits just like original parts. Manufactured from fuel resistant, rubber membrane with silicon bronze center plunger hardware. Fits weber 40, 44, and 48 idf early model carbs with roller on accelerator pump arm.
© 2024 Automobile Atlanta Inc.
505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844
|